crocket81
New member
Just bought this tractor two weeks ago. Was wondering if it is common to have to release clutch almost all the way before it engages?
Massey 471 clutch
- Thread starter crocket81
- Start date
- Views: 6599
pathunt
Bronze Member
- Joined
- Feb 17, 2012
- Messages
- 54
- Location
- Adair County, Northeast Oklahoma
- Tractor
- Massey-Ferguson 251XE
crocket81:
I have a 251 with the Massey two-stage clutch. In the 251/451 Manual, the clutch releases for the pto in the first few inches, then it picks up the clutch for the gears. The manual gives a picture with the adjustment for the 2nd stage. Did you get a manual with the tractor - even the operator's manual will be helpful.
Starkiller Hollow, Oklahoma
I have a 251 with the Massey two-stage clutch. In the 251/451 Manual, the clutch releases for the pto in the first few inches, then it picks up the clutch for the gears. The manual gives a picture with the adjustment for the 2nd stage. Did you get a manual with the tractor - even the operator's manual will be helpful.
Starkiller Hollow, Oklahoma
Last edited:
DLTTrekkers
Veteran Member
DLTTrekkers
Veteran Member
Mybe this wil help ? 0.060" between head of bolt and intermediatplate
jimmyhouser
Gold Member
- Joined
- Feb 4, 2018
- Messages
- 260
- Location
- Charleston, SC
- Tractor
- Massey 1734E, Allis 5030, Case VAC, Ferguson F40
These tractors have a continuous running release bearing. I'm pretty sure it's appropriate for the machine to act that way.
