Massey Ferguson 1010 3 point lift not working

[Bmdoyle82]

Hello, I know this has been discussed because it's a common problem but I can't seem to find any answers. I have a 1010 2wd series 2961. 3 point was working and stopped from what previous owner said so I changed the fluid and filter 2 times because it was milky. It will raise up with no weight but if I push down on it, it won't raise. I've tried turning the stay and float knob and no luck. Any help would be greatly appreciated

 

[jimmyhouser]

Hello, I know this has been discussed because it's a common problem but I can't seem to find any answers. I have a 1010 2wd series 2961. 3 point was working and stopped from what previous owner said so I changed the fluid and filter 2 times because it was milky. It will raise up with no weight but if I push down on it, it won't raise. I've tried turning the stay and float knob and no luck. Any help would be greatly appreciated

You'll have to check hydraulic pressure at the lift cover and go from there. I don't have a 1010 in front of me right now, but I'll see if I can get my hands on a manual.

 

[Bmdoyle82]

Ok I'll have to check the pressure

 

[HikoJoe]

I've attached the section of the MF 1010 service manual that deals with the hydraulics. Hope this helps.