misfit125
New member
What should the pressure be and where do I connect the gauge to check pressure on a MF 175? The lift raises very slow and immediately goes down when engine shuts down.
Massey Ferguson 175 Hydraulic Problems
- Thread starter misfit125
- Start date
- Views: 7583
-
- Tags
- massey ferguson 175
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
If you want to check the pressure, either plug a hyd gage into the work ports QD's, or install a hyd gage in the IN port of the loader valve and you can check everything hyd .
The piston seals could be bad.
The valve could be bad.
The pump could be bad.
A relief valve could be open.
A flow and pressure check would be the best thing to do.
Pressure might be in the 2000 psi area with a good pump.
The piston seals could be bad.
The valve could be bad.
The pump could be bad.
A relief valve could be open.
A flow and pressure check would be the best thing to do.
Pressure might be in the 2000 psi area with a good pump.