I am looking at a set of disc, for my 37 hp Kubota that weight 845 lbs with 20, 18" disc. I like the set except that to adjust the angle you have to remove a bolt. For various reasons I adjust my current set quite often and to do so all I have to do is remove a pin. Could I replace the bolt with a pin without doing damage? For those of you who have Massey disc what is your opinion of them? Thanks!
Massey Ferguson disc set
- Thread starter LabLuvR
- Start date
- Views: 979
JerryG
Super Member
If it is made the way that I think that it is, it would be fine to use a pin.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
I had ( have ) a ford dual ganged set that changed angles with a bolt.. and currently has an "L" shaped piece of rebar inthere right now /forums/images/graemlins/shocked.gif
Pin sounds fine.. get one with a hairclip .. etc.
Soundguy
Pin sounds fine.. get one with a hairclip .. etc.
Soundguy