MF 246 loader-in need of a main lift cylinder.............

[jltrent]

Where can I get an aftermarket main lift cylinder for the loader? The main push rod has rust on it as the chrome from the factory must have not been very thick. Anybody know a company to contact. I would check with Massey, but I am sure it would be very expensive. It is leaking pretty bad as the rust has shot the seal. Thanks for any help.


It is a loader like this and I need one main cylinder.

http://www.tractorhouse.com/listingsdetail/detail.aspx?OHID=7387777

 

[Masseywrench]

Do you know the bore size and stroke of the cylinder? Some are stamped on the main body.

Cheapest way out would be for you to find a hydraulic shop and have them make you a new ram using your existing end on the ram now.