MF 65 Planetary shift won't go into High

   / MF 65 Planetary shift won't go into High
  • Thread Starter
#11  
Thanks Patrick. That is actually very helpful. I decided to wait before proceeding till my garage is built. But first the road must go in, mud dry up and utilities mark for excavation. I will advise what happens in about a month or so hopefully!
 
   / MF 65 Planetary shift won't go into High #12  
You need remove top cover off rearend where the lift arms go . Under the seat . You can service the rear planetary from here .I don't think you need to split the tractor but it will be easier to work on if you do . You will see the fork moves the gear in and out of the planetary. This is where you'll find the trouble . It's just above the hydraulic pump.
Good luck . Also be aware that there are two different thicknesses available for that planetary. You may need to measure if you buy parts. But you should be able to tack weld the "gear" back in. Good luck.
 

Tractor & Equipment Auctions

2025 JOHN DEERE 408R LOT NUMBER 10 (A53084)
2025 JOHN DEERE...
KENWORTH ROLLBACK TOW TRUCK (A52706)
KENWORTH ROLLBACK...
2024 JOHN DEERE 6110M LOT NUMBER 56 (A53084)
2024 JOHN DEERE...
2020 Exiss Escape 7306 LQ T/A Gooseneck Horse Trailer (A50322)
2020 Exiss Escape...
2014 Ford Transit Connect Cargo Van (A54814)
2014 Ford Transit...
2020 KOMATSU PC360LC-11 EXCAVATOR (A51246)
2020 KOMATSU...
 
Top