BlacknTan
Platinum Member
I'm a Kubota guy, so I hope I'm not intruding here, but I've been looking at these spacers myself. Just have to take some measurements before I order.
I spoke to a gent on the phone at Adaptec. I was informed that the spacers are machined from 6061 aluminum. I'd prefer 7075, which would negate the need for protection from corrosion, but I don't want to pay the extra cost of 7075. So, I'll probably ask to have them hard anodized.. No fear of corrosion then.
Looks like a nice product, and congrats to all that have installed them!
I spoke to a gent on the phone at Adaptec. I was informed that the spacers are machined from 6061 aluminum. I'd prefer 7075, which would negate the need for protection from corrosion, but I don't want to pay the extra cost of 7075. So, I'll probably ask to have them hard anodized.. No fear of corrosion then.
Looks like a nice product, and congrats to all that have installed them!
