Need Help Please !!!! MF 50? industrial

[banjodunn]

G'day just done an engine rebuild on a 50H and it's hyd res is in the l/h loader frame upright and the pump is driven through the hole in the axle pivot also the shuttle shift takes dexron 111 or equiv as prev stated


Jon

 

[tolerance]

I am with u I have one for a year kind of lost. And have a oil leek out of trans at a cotter key

 

[skyhook]

I am with u I have one for a year kind of lost. And have a oil leek out of trans at a cotter key

Probably a bad seal inside or a blocked filter screen.
Not sure about the MF 50,
But my MF60 Industrial takes MF Permatran III or equivalent, not the red trans oil.

 

[Don87]

I am with u I have one for a year kind of lost. And have a oil leek out of trans at a cotter key

What color is the oil you are leaking? If it's red, the front seal is out of your transmission (the above posts say that the MF50 uses DexronIII for hydraulic oil) that's transmission fluid for cars., if it's not red, then it's more than likely the rear seal on the engine and engine oil is coming out where the cotter pin is.

 

[8151]

rear hydralic lift will not raise the gannon. i have rebuilt top cover cylinder and piston

 

[simonsays]

rear hydralic lift will not raise the gannon. i have rebuilt top cover cylinder and piston

figured it out?

 

[JWR]

I have a 30E A little smaller machine . Industrial TLB shuttle shift .
The transmission takes MF Permatran III. There are any number of cross over oils. Just read the can and look for Permatran III. It is not straight hydraulic oil. My machine takes almost 15 gal between transmission and rear end. This spring I will do the 1000 hr change for the first time and I never expect to do it again. I know a fair amount about the machine , yours is older I think but maybe I can help. MF ag is now owned by Agro. MF industrial is owned by Terex. The local MF ag dealer here told me he can get me any parts I need.

MF is owned by AGCO not Agro.