OP
Alien
Elite Member
I start about 2 - 3 feet before the stump and work around it.
Need more down pressure on my 3PL for a Ripper
- Thread starter Alien
- Start date
- Views: 8502
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,889
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
Try moving the top link to the bottom hole like jeff9366 mentioned:
OP
Alien
Elite Member
Will try that
OP
Alien
Elite Member
I moved the top link as Jeff suggested but it made no difference. Had a pause while I fitted a Quick Hitch system. It gives me another 4" length on the lift arms. It also put more angle on the tooth.
I strapped a bag of cement onto the top of the ripper and it made a big difference. It could use a little more weight but it is working a lot better. I managed to get it deep enough to rip some large roots around a stump that I hadn't been able to shift and once I pulled them up the stump gave in and toppled. Thanks for the suggestions. Problem solved.
I strapped a bag of cement onto the top of the ripper and it made a big difference. It could use a little more weight but it is working a lot better. I managed to get it deep enough to rip some large roots around a stump that I hadn't been able to shift and once I pulled them up the stump gave in and toppled. Thanks for the suggestions. Problem solved.
Egon
Epic Contributor
Have you checked the tip angle when it’s fully down?
As per the second post!
As per the second post!
LouNY
Super Star Member
- Joined
- Jul 4, 2015
- Messages
- 12,301
- Location
- Greenwich, NY
- Tractor
- Branson 8050, IH 574, Oliver 1550 Diesel Utility (traded in on Branson) NH 8160. Kioti CK2620SECH
As far as which hole to use for the top link on your tractor there are a couple of variables.
Read your manual for some idea of which to use.
Also "if" your tractor is equipped with draft control your manual will provide the information if one position is more sensitive for the draft control then the other. Most of the smaller draft control equipped tractors sense the pull on the top link bracket.
In the case of the ripper it may be flattening the shoe out at it's designed depth,
one way to check that is to back over a ditch or hole and lower the ripper down to the desired depth and view the angle of attack at that level.
Read your manual for some idea of which to use.
Also "if" your tractor is equipped with draft control your manual will provide the information if one position is more sensitive for the draft control then the other. Most of the smaller draft control equipped tractors sense the pull on the top link bracket.
In the case of the ripper it may be flattening the shoe out at it's designed depth,
one way to check that is to back over a ditch or hole and lower the ripper down to the desired depth and view the angle of attack at that level.
OP
Alien
Elite Member
It has a good angle when lowered right down. It is working well with the weight. Just need to add some barbell weights LOL
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,889
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
OP
Alien
Elite Member
Exactly! I often see stuff like that sitting on sidewalks that folks are trying to get rid of so I will grab some one day. 30 - 40 kg would be just right. I only have 20 kg at the moment but it is working.
