need page 818 of 4310 manual

[chickenman]

can anyone send me a copy of page 818 " removal of control panel"
of the jd maint. manual for 4310?

 

[beenthere]

On my CD manual, page 818 of the 4310 has to do with Seat and Seat support, and Seat Close Out panel.

Looking for the "removal of control panel" that you asked for.

 

[beenthere]

This is what I found (page 822)

<font color="red"> Control Panel
Removal:
1. Disconnect negative ( - ) battery cable.
2. Remove steering wheel. See "Steering Wheel" on
page 821.
3. Remove throttle control knob.
NOTE: On ePowrReverser machines, remove left cowl
and remove two bolts securing the reverser lever
bracket. Install in reverse order.
4. Remove screws securing control panel; lift off the panel.
5. Lift rear of panel and tilt panel forward. Reach under
panel and spread tilt steering lever arms away from
steering column steering wheel tilt mechanism.
6. Lift panel up and disconnect all wiring harness
connectors to control panel.
7. Remove control panel.
Installation:
Installation is the reverse of removal.

</font>

Do you need the "Steering Wheel" directions?

 

[beenthere]

(from page 821)
<font color="red">
Steering Wheel
Removal:
1. Remove steering wheel center cap.
2. Remove lock nut.
3. Remove steering wheel. If necessary, use a suitable
puller.
Installation:
NOTE: Lubricate the steering shaft splines with
general purpose grease before installing steering
wheel.

1. Remove center cap retaining ring from steering wheel.
2. Install steering wheel and retain with nut. Tighten
steering wheel nut to 39 - 49 N&#8226;m (29 - 36 lb-ft).
3. Install plastic retaining ring to steering wheel center cap.
4. Install center cap and retaining ring to steering wheel.
</font>

 

[chickenman]

thanks, that helps

 

[chickenman]

ok, parts all replaced

it wasnt hard

 

[txhawg]

Where do you get these manuals? Did they come with your tractor, or did you order them separately?

 

[chickenman]

i have a manual on cd on order from my jd dealer