The hour meter on my 240D rolls over at 999, but judging by wear and tear and general condition I would say about 1700 hrs on it. still runs like a top, uses no oil and runs no higher than 170 degrees no matter how hard I work it.
new guy, old questions
- Thread starter Ridge
- Start date
- Views: 3097
Smoody
Platinum Member
Ridge, a diesel engine can last a long time, I doubt any will make it to 8-10k hours without some repair or rebuild even with strict maintenance.
The ones rebuilt before 2,000 hours are probably neglected, abused and have been overheated at some point. I have 800 hours on mine with nothing needing repaired/replaced but a shifter spring, I do change the oil /filter at 50 hours, fuel filter every spring, new air filter every other spring, hydraulic fluid every 300 hours, I know the manual states the intervals to be longer but I think its cheap insurance to keep the fluids fresh.
The ones rebuilt before 2,000 hours are probably neglected, abused and have been overheated at some point. I have 800 hours on mine with nothing needing repaired/replaced but a shifter spring, I do change the oil /filter at 50 hours, fuel filter every spring, new air filter every other spring, hydraulic fluid every 300 hours, I know the manual states the intervals to be longer but I think its cheap insurance to keep the fluids fresh.
normde2001
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 4,163
Unless you bought your tractor new or have a "0000.0" odometer, And not a Vn reman, there is no way to know.
I was a Maintence Manager at a trucking company for 26 yrs a few years back and we seen most of our engines (Detroit) run approx. 26k to 34k hrs before overhaul, if we changed a head gasket in the 22k hr or more we would normally overhaul it as we had 12 hrs of the 40 already into it. i know the small engines are different but i wasn't sure to what degree. We also oil sampled every change approx. 370-400 hrs (19000-22000 miles) it would vary if the driver would stay out on the road longer than normal.
mus302
Bronze Member
Ridge you may also want to note that on most Yanmars a hour on the meter is a hour at a specified RPM. I think on mine it is 2600 RPM. So it would have to idle at 1000 RPM for 2.6 hours to register 1 hour on the meter.
I just put money down on a YMG1800D, hopefully I made the right choice, I could of had a YM1720D with powershift for same price and close hrs. (500)but I like to keep it simple. We are waiting 4 weeks to pick it up as we are moving to a different area and don't need it where we are now.
