High Compression
Platinum Member
I transferred my Whelen Lindz6's and traffic adviser from the B3030 to the L5740.
New/Old strobe lights
- Thread starter High Compression
- Start date
OP
High Compression
Platinum Member
The controls.
I have a video of how they work, but haven't figured out how to post it yet.
I have a video of how they work, but haven't figured out how to post it yet.
rsewill
Veteran Member
Got a dimmer switch so you don't blind drivers?
Scooby074
Super Member
Looks good. Video will be nice.
A good way to post video is to create (if you dont already have) a youtube account.
You can then post the link to your video in the thread, and the video will be embedded
A good way to post video is to create (if you dont already have) a youtube account.
You can then post the link to your video in the thread, and the video will be embedded
VTFireftr
Silver Member
That controller has a high or low switch. I have the same controller for my lightbar in my F-250.
OP
High Compression
Platinum Member
Thanks, I'll give that a try.
OP
High Compression
Platinum Member
Yup that's right.
mjw357
Platinum Member
Why didn't you put the molex connectors inside the cab, to protect them from the weather?
EDIT: Nevermind, looks like the wires from the LINZ6's were too short for that.
EDIT: Nevermind, looks like the wires from the LINZ6's were too short for that.
OP
High Compression
Platinum Member
That was easy. Here's the video.
Safety Lighting on Kubota L5740 - YouTube
My first video, so I have a lot to learn. I'll try to do better next time.
OP
High Compression
Platinum Member
I did on the B3030 and it was a real pain to remove them. I might as well just used butt connectors. Also the connectors won't go through the little hole and grommet. So I did it this way this time. I'll just have to see if I have any issues. If so, I'll just have to order some Weatherpack connectors.