Farming Bees
New member
- Joined
- Dec 9, 2020
- Messages
- 19
- Tractor
- 1025R
Hi Ya'll. Finally bit the bullet and purchased a TerraForce tiller for my 1025R JD. Wondering if anyone can answer a few questions?
First off, is it safe to use the tiller with quick hitch systems and wondering if there are any safety issues I need to be aware of? I've had to add bushings to make the pins fit securely for the iMatch.
Second, Attaching the shaft - the instructions show that the slip clutch end should be hooked up to the tractors PTO. However, that is the heavier end and is also the end you need to use a screwdriver to secure it onto the PTO. The other end has a "push pin" of sorts and allows that end to clamp on the tillers mount very easily. Can this be reversed and used safely?
Third, this tiller was shipped on a nice metal stand screwed onto the shipping pallet. Unfortunately I didn't take a picture of exactly how it sat upright on it. I've tried several different ways but can't figure out how to place it back onto the stand so that it is stable again. Anyone know? Pictures?
First off, is it safe to use the tiller with quick hitch systems and wondering if there are any safety issues I need to be aware of? I've had to add bushings to make the pins fit securely for the iMatch.
Second, Attaching the shaft - the instructions show that the slip clutch end should be hooked up to the tractors PTO. However, that is the heavier end and is also the end you need to use a screwdriver to secure it onto the PTO. The other end has a "push pin" of sorts and allows that end to clamp on the tillers mount very easily. Can this be reversed and used safely?
Third, this tiller was shipped on a nice metal stand screwed onto the shipping pallet. Unfortunately I didn't take a picture of exactly how it sat upright on it. I've tried several different ways but can't figure out how to place it back onto the stand so that it is stable again. Anyone know? Pictures?