New (to me) BX2200

[TripleR]

Hey guys I need some advice,
I have a kubota BX2200 and I just replaced the shut off solenoid and the engine switch and I still don't have power on the red wire that goes conected on the solenoid. I traced the wire and it ends under the dash board on a 4 wire terminal. Now my question, should it be a relay of some kind connected on it and if it is what's it called?

Sorry I can't help with that; anything electrical and off to the dealer for me.

Thanks for all the nice comments. The more I play with the bx2200, the more I like it. I decided to go ahead and do a complete fluids service on it, so I went by the Kubota dealer today, and bought oil, air, hydro, and fuel filters. Also bought 2.5 gallons of SUDT2, then over to Walmart for 5 qts of Shell 5w-40 synthetic.

Had to order upper and lower radiator hoses, but they should be in by Thurs. I already had 2 gallons of prestone long life, and distilled water on hand for the coolant change.

So, add another couple hundred to the price.
Sooooooo, what have I missed?

K

Did you do a front axle fluid change?

These things don't require a lot of maintenance. I use an air compressor to keep the screens clean and blow the grass out of the deck and grease all the fittings; back U joint is kind of hard, but you get use to it.

They make an improved seat for it I think, but ours has the original.