New tractor owner

[GregbkH]

Today I became a new tractor owner. I have been studying tractors for over a year. I stumbled across this site last year and thanks to the knowledgeable people here, I finally decided on a 2010 New Holland 3045. It has the TL250 loader and the 758C back hoe. I'm having 3 rear remotes installed and all 4 tires loaded with Rim Guard. I also ordered the Land Pride RBT3584 rear blade with all the hydraulics for my first implement.

Sorry no pics until delivery (hopefully next weekend).

Thanks for your help

Greg

 

[nickel plate]

WOW! Get it on GregbkH and welcome to TBN! Pray tell, what are you planning on using the third set of rear remotes for? Keep us in touch as you go along and remember-photos are required!:thumbsup:

 

[JC-jetro]

Today I became a new tractor owner. I have been studying tractors for over a year. I stumbled across this site last year and thanks to the knowledgeable people here, I finally decided on a 2010 New Holland 3045. It has the TL250 loader and the 758C back hoe. I'm having 3 rear remotes installed and all 4 tires loaded with Rim Guard. I also ordered the Land Pride RBT3584 rear blade with all the hydraulics for my first implement.

Sorry no pics until delivery (hopefully next weekend).

Thanks for your help

Greg

Cool and welcome to TBN Blue,

All on the spot choices. Please post pics asap so the drooling may start.

Good luck and take it nice and slow till your tractor breaks in well.

JC,

 

[GregbkH]

WOW! Get it on GregbkH and welcome to TBN! Pray tell, what are you planning on using the third set of rear remotes for? Keep us in touch as you go along and remember-photos are required!:thumbsup:

I wanted to make sure that I had enough!! I plan on getting a TnT and want to be able to run what ever hyd component an implement may have.

 

[acme97]

Welcome. What is your first project and do you have any pics of this fine collection of machines?

 

[nickel plate]

I wanted to make sure that I had enough!! I plan on getting a TnT and want to be able to run what ever hyd component an implement may have.

I have two sets of remotes and a Woods block for the backhoe all in one stack so adding a third set of remotes wouldn't be feasible do to so much already going on there. I checked the stud lengths for the third set and they are too short to connect them all. What I do is detach the tilt cylinder when I run the wood splitter.

 

[GregbkH]

Welcome. What is your first project and do you have any pics of this fine collection of machines?

Thanks for the comments.

I guess my first project will be to dig out a few stumps in order to make it easier to navigate my trails in the woods.

Here are a few pics as it sat on the lot.

 

[acme97]

Nice looking machine. Have you thought about putting a thumb on the BH? I have a Kubota L35 and wish I had done that. I'm looking at getting one from Bro-Tech, but man are they expensive.

 

[RADIUM]

Welcome aboard nice piece of equipment you got there . There is a lot of good advice on these forms if a problem should occur which I highly doubt that's one tough tractor. The thumb on the backhoe might not be a bad idea to help with stumps and other debris if one is available for that model take care

 

[GregbkH]

A back hoe thumb is definately on my list. There are so many attachements that I want/need!!! I have to take it easy for a while or the significant other may take notice of my addiction! :thumbsup: