18tinner
New member
been reading here off and on for quite a few years. Every time I come here I get that darn pop up to join. Well now I have finally done it.
I currently run a Kubota bx2230 and have just purchased a kk tg 48 xb tiller for it. I measure the shaft length four times last night BEFORE I cut it too short
. All I can say is that the you tube video from ETA does not work for all situations.
Just getting ready to go out and pop the u-joints off so i can heat up the yokes and try to rid them of the shafts.
Fortunately the cut offs are long enough to do the job once i get them in.
Any one have a reasonably priced phd for sale.
Bob
I currently run a Kubota bx2230 and have just purchased a kk tg 48 xb tiller for it. I measure the shaft length four times last night BEFORE I cut it too short
. All I can say is that the you tube video from ETA does not work for all situations. Just getting ready to go out and pop the u-joints off so i can heat up the yokes and try to rid them of the shafts.
Fortunately the cut offs are long enough to do the job once i get them in.
Any one have a reasonably priced phd for sale.
Bob
