NH Rollbar Rake Teeth Spring or Rubber?

   / NH Rollbar Rake Teeth Spring or Rubber? #1  

semi_farmer

New member
Joined
Jun 19, 2009
Messages
4
I have a NH 258 rake it has the rubber teeth on it. Has any one used a combination of spring teeth and rubber teeth on the same rake. Or do I just stick with the rubber?

Looking for input?
 
   / NH Rollbar Rake Teeth Spring or Rubber? #2  
From 50 yds, its hard to see the difference. The rubber is supposed to be more friendly in rocky areas. If you are scratching the ground all the time with either type of tooth, the rake is set way too low. The teeth I use are steel from TSC. If you are worried about leaving a few out in the field, run a few strands of fence wire thru the spring loops to keep them hanging around. Be sure to change them out asap, 'cause the busted ones make a lot of noise. All that really matters is whether the intermixed tooth types are the same overall length from the bar to the ground.
 
   / NH Rollbar Rake Teeth Spring or Rubber? #3  
Real good advice on running a wire thru the spring eye - especially on old teeth. Found a spring tooth in a bale the other day while feeding the horses. :eek: Made it through the baler without banging around in the chamber or shearing a pin or maybe worse..

AKfish
 

Tractor & Equipment Auctions

2005 Ford F-150 Pickup Truck (A45336)
2005 Ford F-150...
Heavy Duty Skid Steer Auger SSECAG-Y W/ 6", 12", and 14" Bits (A43476)
Heavy Duty Skid...
2021 John Deere 17G Mini Excavator (A45336)
2021 John Deere...
2019 Bobcat E32i Excavator (A46683)
2019 Bobcat E32i...
2015 Portable Restroom T/A Trailer with Trash Storage Compartment (A45336)
2015 Portable...
2018 Ford SuperDuty F-250 (A48561)
2018 Ford...
 
Top