The manual I downloaded for my NAA says to check the fluid levels on the trans and hyds with the dip stick. Even says the hyd case has a dip stick on the right side of the case. There are no sticks that I can find. There are large filler holes so I can look into the cases to see the fluid levels. Should I just fill them up to near the top?
No dip sticks on trans. or hyd. cases. how much fluid?
- Thread starter krogers
- Start date
- Views: 698
EdGooding
Gold Member
- Joined
- Sep 12, 2016
- Messages
- 255
- Location
- Montpelier, VA
- Tractor
- 2006 Massey-Ferguson MF-1533, 1973 Ford 3000, 1952 Ford 8N
Do not fill them to the top. This is a picture of my 8N but I believe it should be the same deal with your NAA. If the dipstick is missing from this location, remove the bottom bolt that is circled and fill to where the hydraulic fluid starts to run out of this bolt hole:
Attachments
John0829
Veteran Member
Your dipstick is on the opposite side of your tractor from the image above. If you drain the system it should hold 2 gallons to be full.
