No hydraulics after hose change

[cucamelsmd15]

Workmaster 40 and 110TL loader here. The backstory is that I had a burst hose, and two weeping hoses at the crimp connectors. Had three new hoses made and put them on today. I now have no hydraulics. Front or rear, neither work. Looked through the manuals for both, I think the hoses are hooked up correctly, and I am stumped. Help!

 

[jimmysisson]

I assume you have correct fluid, filled up. You will have to cycle the loader lever up and down repeatedly to get the air out. Was it loader hoses you replaced? Make sure quick connects are fully seated. Did you reuse yours?
Jim

 

[Egon]

Check the connect order again & make sure the QD's are on properly.

 

[cucamelsmd15]

These aren't the quick connect hoses, they're the hoses that run from the valve at the deck to the loader control. They're upstream of the quick connects.

As far as fluid goes, it's at the low line on the dipstick.

 

[thcri]

Are they air locked? Take the high end off and fill with hydraulic fluid and reattach maybe.