No Rear Hydraulics for BH65 and 3PH

[Ottawa King]

OK - Major relief! I rechecked every connection, as per Beezfun's advice and in order to start simple to difficult. Keeping in mind I'd done this already, I noticed that the bottom connection appeared to be leaking. When I wiggled it, off it came! Clogged with crap. I cleaned it up and reinstalled. All is well. I am going to install the pressure gauge and triple check all the connections again. Just wanted to thank all of you for the help. It was all excellent and very much appreciated!

 

[BrierPatch]

Glad you got it fixed and it was something simple (read that as cheap). Don't forget what Beckmurph said though. There is supposed to be a manual flip catch lock to make sure the 3pt lever stays in the lowered position when the BH is on. :thumbsup:

 

[haveissues]

There is a warning on my b2620 that says the backhoe seals will leak if the 3pt hitch is not fully down while the backhoe is mounted.

 

[J_J]

You mentioned a hose from the hyd block going back to under the seat with a QD on it.

Is anything plugged into it?

That would be the only supply for the back of the tractor.

When the BH is not installed, that QD should be plugged into a line going to the remote or the 3pt.

If the BH is installed and has PB, then the PB line from the BH would return and plug into the 3pt.

The return from the BH would go to tank.

When using the BH, the 3pt is usually non functional.