RoyKing
Platinum Member
IT Is a FMC SIDEWINDER, bing or goggle clutch plates even on amazon and ebay. Parts diagram, I think they sold off and became Bush Hog. I used bush hog blades I found at an auction new in box for $20.
Old brush mower slip clutch questions
- Thread starter Thunder chicken
- Start date
- Views: 2356
OP
Thunder chicken
Gold Member
well had the ole mower out, ran fine for about 4 hours then finally found a bush/stump that was a bit much.
Broke the U joint/clutch yoke.
The initial break was quite dramatic, pieces flinging! safety shield got beat up, then the shaft fell down and just turned around harmlessly till i got the pto disengaged.
Search now on for a replacement! likely easier to find a whole new slip clutch?
Broke the U joint/clutch yoke.
The initial break was quite dramatic, pieces flinging! safety shield got beat up, then the shaft fell down and just turned around harmlessly till i got the pto disengaged. Search now on for a replacement! likely easier to find a whole new slip clutch?
jonsstihl
Veteran Member
Sounds like the slip clutch never slipped.
probably easier to find a whole new shaft with a slip clutch on it. I have seen some for around 200-300 dollars for the complete shaft and slip clutch. Just need to figure out what length to get
probably easier to find a whole new shaft with a slip clutch on it. I have seen some for around 200-300 dollars for the complete shaft and slip clutch. Just need to figure out what length to get
3gunr
Veteran Member
- Joined
- Apr 17, 2018
- Messages
- 1,182
- Location
- wentzville mo
- Tractor
- mahindra 2538 mahindra 2810 cub cadet 7260 massey 255
look up georgia equipment co .They have great prices on drive shafts and slip clutches.I have bought several from them and they work great.
RoyKing
Platinum Member
That is an old FMC sidewinder, parts all over the place. I need some clutch plates for mine, just moved it from and old ford 3000 diesel with probable 35hp to my new Kubota M7060 and we've been out cutting pine saplings anything that we can back over. Found best price from Jensales.com mainly cheaper S&H. Just fix it, since you'll be tearing it down put in some new clutch's. That unit is 50+ years old.
RoyKing
Platinum Member
Upon rebuilding mine, new clutch plates, your yoke connects to end of gearbox input shaft to keep the clutch centered, this is slip fit, it could have been rusted and kept the clutch from slipping. I've cleaned the rust and clutch material off the three plates and will be putting back into service tomorrow and post the results after another session of pine tree removal.