schmism
Super Member
so ive done my share of searching round hear, and i would have thought i would have come up with all kinds of "what cylinders have you used on your project" kind of thing were people talked specifics of the xyz9000 vs the xyz9002 or whatever but alais....
Unfortuntly i get the impression most just scrounge something off of some older scrap impliment/tractor or toss a dart at the hydrolics catalog and hope they come up lucky (and if not... they "make it work")
so ya add me to the list of people that would greatly apreciate some good specfic info on the hydrolics people have used and why they chose them, how did they go about it (size, stroke, diameter etc)
as an engineer im more "plan it out before hand" types
Unfortuntly i get the impression most just scrounge something off of some older scrap impliment/tractor or toss a dart at the hydrolics catalog and hope they come up lucky (and if not... they "make it work")
so ya add me to the list of people that would greatly apreciate some good specfic info on the hydrolics people have used and why they chose them, how did they go about it (size, stroke, diameter etc)
as an engineer im more "plan it out before hand" types
