farmerdean
Member
how do I remove an overrunning coupler from a ford 8n?
overrunning coupler
- Thread starter farmerdean
- Start date
- Views: 1080
grsthegreat
Super Star Member
if i remember correctly, theres a drive pin run thru it. This prevent the coupler/clutch from coming off of the spindle.
tessiers
Platinum Member
- Joined
- Sep 22, 2007
- Messages
- 727
- Location
- Central Maine
- Tractor
- 05' JD 790 - 53' Ford NAA - 70' Massey Fergusen 135 diesel - 67' John Deere 3020 deisel - 77' John Deere 2130 - 1950 John Deere MC
yep, take out the grease fittings on each side and turn it till the holes line up with the roll pin, then drive it out with a punch. Your PTO shaft on the tractor is probably 1 1/8" so if you plan to use it you will need an adapter, unless it has been upgraded.
OP
farmerdean
Member
thanks
