PHD Storage?

[buckeyefarmer]

Old pallet, couple 2x4s

 

[Mike_Kanzer]

Hang mine from a rafter with a chain in my old tractor shed

 

[mvwwld4u]

Tying the auger bit up near the gearbox and again about a third the up from the bottom to a utility pole, fence post, or a tree works pretty good too but it doesn't keep the shaft end or the pins off the ground unless you place them on a block of some sort.

 

[denmis]

Mine hangs from the rafter on the lean-to on the side of my barn. It's hooked to a come-along, so I use that to move it up or down to align it. Works pretty well, I put it on the tractor last week and it only took maybe 10 minutes to get it hooked up, probably less.