Picked up my L45 TLB!

   / Picked up my L45 TLB! #11  
Hi Workinallthetime

Attached are a couple of photos of mods I made to the Kubota 4 in 1 before painting it so you can see the differences. I found the hoses were not very well protected and spoil could also hit the cylinders so I increased the height of the back of the bucket by 6" and added cover plates to protect the cylinders. This also increases the capacity of the bucket to the point that if I fill it with heavy wet soil the L45 won't lift it all the way up but it always gets it high enough that I can dump the material in my dumping trailer. Before the modifications I never had any issues with lifting a full bucket.

L45 4in1 mods front view 120515.jpgL45 4in1 mods rear view 120515.jpg

It sure is handy when you need to pick stuff up but it has a pronounced hump in the bottom which makes it a little more difficult to push into a pile. All in all though I would still get the 4 in 1 - especially with a new machine. I kept the 66" light duty bucket from my B26 which carries almost as much material and has a thinner edge when I want to really push into a pile.

Good luck with your new purchase.

Regards,

Lauren
 

Tractor & Equipment Auctions

2019 Fontaine Traverse HT T/A 48ft. 41 Ton Lowboy Trailer (A49461)
2019 Fontaine...
2022 Down2Earth 82in x 36ft Two-Car Hauler (A51039)
2022 Down2Earth...
2017 UTILITY VS2RA 53FT REEFER TRAILER (A51222)
2017 UTILITY VS2RA...
2016 WITZCO RG-35 RGN LOWBOY TRAILER (A50459)
2016 WITZCO RG-35...
2013 INTERNATIONAL WORKSTAR 7600 SBA 6X4 DUMP TRK (A51406)
2013 INTERNATIONAL...
AIR POWERED TONGS (A50854)
AIR POWERED TONGS...
 
Top