Pictures of my new JD 2520!

[Runner]

Aggie,

Unfortunately, when the 2520 rear wheels are in the "wide" position, the valve stems are on the inside. In the wide position, the depression closest to the center of the wheel is concave, whereas, in the narrow position, it is convex (when looking at it from the side). Did that make sense?

 

[Artesia Aggie]

Thanks. The loader manual says to run in the "wide" position but it is not very specific from there. It is difficult to eyeball the difference.

 

[peter_vii]

Here they are pictures of my new tractor

What is the "real" (not advertised) ground clearance on this tractor?

Thinking about getting one for my garden.

Thanks,
Peter

 

[Artesia Aggie]

I'll put a tape to it tomorrow andlet you know

 

[Artesia Aggie]

What is the "real" (not advertised) ground clearance on this tractor?

Thinking about getting one for my garden.

Thanks,
Peter

From the lowest point I can find which is where the draw bar connects to the tractor, I measure 12". Hope that helps.

 

[pkav32]

Artesia Aggie,
I love that set-up. I have the same set-up at home. You'll love it. Just be careful when you brush hog with the 2048rc. When you try to get under trees etc.. in reverse . You have to lift alittle so the sides do not bend inward. Not as reenforced as one would think. I found that out the hard way. Nothing a big hammer could not take care of. Enjoy it!