3-Point Hitch Please - a measurement on Class III Boomers

[DocHeb]

I am not at my tractor and I need a measurement for a Class III TC34/40/45.

What is the height (approximately to the center of the hole) of the lower arms of the three point when they at their lowest position?

 

[jinman]

Chris, do you mean at the hitch balls? I'm away from my tractor right now too, but I'm sure the hitch ball will lower to around 6" off the ground. I do have TnT and that probably puts me a bit lower than some.

 

[DocHeb]

Yes, at the center hole of the lower arm hitch balls

 

[Jackfr]

Chris

Measured to the center of the 3pt lift arm ball hole on the non adjusting side (left) on a flat concrete floor 7".

I have a 2003 TC45DA with loaded R-4 17.5L-24

Jack

 

[DocHeb]

Measured to the center of the 3pt lift arm ball hole on the non adjusting side (left) on a flat concrete floor 7".

I have a 2003 TC45DA with loaded R-4 17.5L-24

Thanks, I have R-4s also. That was about my recollection, and I will design a little lee-way in. Thanks