Post frame roof only questions.

   / Post frame roof only questions.
  • Thread Starter
#11  
Lenny,questions like " Is your 2x8 sandwiched plate lying flat or edgewise on top of posts? Or nailed bolted to the outside or inside of the posts?",I must agree with Rustyiron.
"From your post's "language", I'd seek out a bit of local help & advice on this build"
.

I was taught by an older carpenter that the top plate laid on top of the wall. The top band was on the sides.

A sandwiched 2x8 would be approx 4" thick. I wasn't sure if you nailed it or bolted it and/or notched the top of the posts to inset part of it.

I've read on the band being placed on the inside of the posts in order for the roof loads to push against the posts. I know they are usually outside.

Though I may sound like an idiot when I typed the question, I have seen or read of all these versions and was just trying to verify what was said.

I do appreciate the answers and information. I asked here because the wealth of knowledge collected here is far greater than I may hear about in my little town.
 

Tractor & Equipment Auctions

STORAGE SHELTER KIT (A53843)
STORAGE SHELTER...
400 Gallon Fuel Tank with Stand and New Pump (A55787)
400 Gallon Fuel...
11'x6'8" Sea Container W/ Side Door (A47477)
11'x6'8" Sea...
PumpJack Brand Pump Jack (A55302)
PumpJack Brand...
Bobcat 72" Skidloader Bucket Broom (A50775)
Bobcat 72"...
Excavator Mounting Plate (A50775)
Excavator Mounting...
 
Top