varmint
Elite Member
- Joined
- Mar 17, 2003
- Messages
- 2,576
- Location
- Northern Maryland
- Tractor
- Kubota B8200, then a Kubota L3130 HST, now a Kubota L3400 HST
Sorry to take so long to respond- been busy. The left side loader bracket interferred with the ps cylinder and misc., and I had to remove a lot of metal. If you look at the photo again, you can see where it was cut out, front and back. I was concerned about weakening it, so it put a 3" x 3" heavy steel tube underneath, bolted to the bottom of each side. As we used to say in the midwest: it's hell for stout. I did have to notch the top of the tube so it would clear the drive shaft that goes to the front axle.
