Pulley drifting

   / Pulley drifting #11  
If there is a mark on motor shaft where set screw seats (when pulleys properly aligned), take a drill bit and put a dimple on shaft on that mark, use drill bit approximately the same diameter bit as set screw, and just go to point where flutes on drill bit disappear, no deeper... It creates a dimple on motor shaft where end of setscrew can seat.... Real problem is probably poor set screw fit in pulley threads...

Dale
 
   / Pulley drifting
  • Thread Starter
#12  
Real problem is probably poor set screw fit in pulley threads...

Dale

That was the case for sure. Locktite seems to be holding, thanks to all.
 

Tractor & Equipment Auctions

2019 Chevrolet Tahoe SUV (A52377)
2019 Chevrolet...
MISSION 4X3X14 CENTRIFUGAL PUMP (A53843)
MISSION 4X3X14...
2004 CATERPILLAR 836G LANDFILL COMPACTOR (A51406)
2004 CATERPILLAR...
2000 WINNEBAGO FORD F550 RV (A52472)
2000 WINNEBAGO...
2014 DRAGON 500 BBL FRAC TANK (A53843)
2014 DRAGON 500...
2021 FREIGHTLINER CASCADIA SLEEPER TRUCK (A54313)
2021 FREIGHTLINER...
 
Top