Question on suction hose

   / Question on suction hose #1  

NCMau

Gold Member
Joined
Nov 5, 2009
Messages
293
Location
NC
Tractor
MF 202/Ford 8N
I have to replace the power steering suction hose. The suction and the pressure are both 1/2" hoses. I would like to use a 3/8" for a flexibility issue and leave the existing 1/2" pressure hose in place. I realize that normally the suction should be larger or at least the same size.
My question is, since the steering is a low volume system, can I get by with a 3/8" for suction?
I would prefer to use the 3/8", but it is not absolutely imperative.
 
   / Question on suction hose #2  
it is not something i would recommend the mfg. already took into account the low flow and used the same size hoses. if it is flexibility try gates or flexdraulic hoses
 
   / Question on suction hose
  • Thread Starter
#3  
Well I didn't really think that I was going to get away with this idea. Thanks for the tip, I'll look into these flex hoses.
 
   / Question on suction hose #4  
A 1/2" suction hose is already smaller than normal. I would not mess with it. If your pump can't get enough fluid because the input hose is too small, you could be looking at some very expensive pump repairs.
 
   / Question on suction hose #5  
Look into some manufacturers 1/2" hose that has thinner wall and more flexible. I think the spec is 100a7
 

Tractor & Equipment Auctions

2016 FREIGHTLINER CASCADIA TANDEM AXLE SLEEPER (A45679)
2016 FREIGHTLINER...
Kubota BX25D 4WD Tractor Loader Backhoe (A49251)
Kubota BX25D 4WD...
40' Container (A49251)
40' Container (A49251)
2017 FREIGHTLINER SPRING 3500 REEFER VAN (A50046)
2017 FREIGHTLINER...
2012 C.GALLEGOS 130BBL (A48992)
2012 C.GALLEGOS...
KOMATSU PC360LC-11 (A48992)
KOMATSU PC360LC-11...
 
Top