Frankenkubota
Elite Member
- Joined
- Jun 11, 2020
- Messages
- 2,827
- Location
- Carthage NC...Deep in the woods
- Tractor
- Kubota MX 5800, SkidPro 4 in 1, Ratchet rake, SkidPro pallet forks
As usual, this is probably old news but.....
Many times when changing implements i have a hard time releasing the pins on the QA.
Turns out, in my case, once i get the attachment "almost" to its storage spot, i hop off and release the pins before i set the attachment on the ground. In other words, the attachment is just "up in the air".
even if it looks like it's sitting flat i guess there is still side pressure or forces holding the pin in.
Only took me 18 months to figure that one out!
Many times when changing implements i have a hard time releasing the pins on the QA.
Turns out, in my case, once i get the attachment "almost" to its storage spot, i hop off and release the pins before i set the attachment on the ground. In other words, the attachment is just "up in the air".
even if it looks like it's sitting flat i guess there is still side pressure or forces holding the pin in.
Only took me 18 months to figure that one out!
