My 1948 JD Model A has an oil leak at the left rear axle. It is apparently due to a bad seal. I found out the those seals are obsolete from the local JD dealership. The service man said that I would have to contact NAPA to see if they could make one. Do any of you have any idea of how this issue can be resolved?
Rear axle seal
- Thread starter DrRon
- Start date
- Views: 993
2manyrocks
Super Member
- Joined
- Jul 28, 2007
- Messages
- 8,385
JD collector association or restoration club might know a substitute
LD1
Epic Contributor
Measure the shaft diameter, and measure the housing bore. I am about 100% certain there is a common seal number that exists that fits those dimensions.
LD1
Epic Contributor
Or some google searching may be helpful John Deere A Rear Seals - Steiner Tractor Parts
rScotty
Super Member
- Joined
- Apr 21, 2001
- Messages
- 9,453
- Location
- Rural mountains - Colorado
- Tractor
- Kubota M59, JD530, JD310SG. Restoring Yanmar YM165D
I get my old two cylinder JD parts from SteinerTractor.com. Order online and it is here in a few days.
They have both the original and upgraded axle seals. So far everything I get from them is top quality.
In fact, that's where my JD dealer gets a lot of his parts too.
rScotty
ROUSTABOUT
Elite Member
- Joined
- Jan 30, 2008
- Messages
- 3,140
- Location
- Luther Willis Hill, AR
- Tractor
- Pettibone, Ford, Massey Ferguson, International, JD, David Bradley, home mades
I've replace a lot of seals. Never bought one at a dealer.
rScotty
Super Member
- Joined
- Apr 21, 2001
- Messages
- 9,453
- Location
- Rural mountains - Colorado
- Tractor
- Kubota M59, JD530, JD310SG. Restoring Yanmar YM165D
Well, at least you did get one issue resolved, that being the knowledge level of the service man at the local JD dealership. Advising someone to ask NAPA make a seal is beyond strange; it's pure sci fi.
rScotty
