sld
Veteran Member
Hi all,
I just did a lot of maintenance on my Ford 1210 4WD. It had sat for awhile so I changed all fluids and filters.
I never noticed this before, but when I raise the 3 pt, it comes up a little jerky. It's not real bad but not as smooth as going down. The only implement I have put on is the rear blade as I am getting ready for moving snow. It was still slightly jerky coming up.
Is this normal? Is there something I should check?
Thanks for the help.
I just did a lot of maintenance on my Ford 1210 4WD. It had sat for awhile so I changed all fluids and filters.
I never noticed this before, but when I raise the 3 pt, it comes up a little jerky. It's not real bad but not as smooth as going down. The only implement I have put on is the rear blade as I am getting ready for moving snow. It was still slightly jerky coming up.
Is this normal? Is there something I should check?
Thanks for the help.