Rebuild shredder gear box
- Thread starter fredm
- Start date
- Views: 2516
RoyJackson
Rest in Peace
- Joined
- Nov 17, 2001
- Messages
- 16,546
- Location
- Bethel, Vermont
- Tractor
- John Deere 4052R Cab,, Deere 855D UTV, Z920A Zero Turn Mower and assorted implements
You'll be a lot better off contacting the implement manufacturer with these questions.
However, I'd make a gasket before using RTV (which is good stuff but it's a bit of a pain to remove if you pull the gearbox off again).
As far as bolt torque...well, good qestion for the manufacturer. Otherwise, look up the torque for the thread size/pitch and grade of bolt and use standard torque values.
However, I'd make a gasket before using RTV (which is good stuff but it's a bit of a pain to remove if you pull the gearbox off again).
As far as bolt torque...well, good qestion for the manufacturer. Otherwise, look up the torque for the thread size/pitch and grade of bolt and use standard torque values.
