REMOTE HYDRAULICS ???
- Thread starter steveky
- Start date
- Views: 1227
Robert_in_NY
Super Member
- Joined
- Aug 1, 2001
- Messages
- 8,586
- Location
- Silver Creek, NY
- Tractor
- Case-IH Farmall 45A, Kubota M8540 Narrow, New Holland TN 65, Bobcat 331, Ford 1920, 1952 John Deere M, Allis Chalmers B, Bombardier Traxter XT, Massey Harris 81RC and a John Deere 3300 combine, Cub Cadet GT1554
I have run my baler off my loader remotes on my New Holland TN. The remotes are the same they just have a joystick to control them instead of the lever. Just make sure if you leave the loader on you use the bucket curl remote so you can raise the loader still. Preferably you will just remove the loader completely and not have it bouncing around.
OP
steveky
Gold Member
Do you change the fittings on the baler or is there a adaptor you can buy?
Robert_in_NY
Super Member
- Joined
- Aug 1, 2001
- Messages
- 8,586
- Location
- Silver Creek, NY
- Tractor
- Case-IH Farmall 45A, Kubota M8540 Narrow, New Holland TN 65, Bobcat 331, Ford 1920, 1952 John Deere M, Allis Chalmers B, Bombardier Traxter XT, Massey Harris 81RC and a John Deere 3300 combine, Cub Cadet GT1554
What do you mean? Are your loader remotes different then the normal rear remote on your tractor? My tractors all have the same Pioneer style remotes so all I have to do is put the pioneer tips on my hydraulic hoses and I am set to go with any of my tractors.
OP
steveky
Gold Member
I looked at it this morning, I'll just have to put females on my baler tie hoses as the loader has male fittings. It shouldn't be a problem at all.
Steve
Steve
Here are some similar links:
