Replace injector pump YM2210D

[Pird]

I need a little advice on installing an injector pump on a YM2210D. My ordered service manuals have not arrived and I would like to go ahead and install the pump without them. Can I just cut off the fuel, replace the pump, bleed the fuel line of air, and go. Seem like there would be a problem with air in the fuel below the bleed point. Any special things to look out for or do? Thanks.

 

[1danny]

You will have to remove the fuel pump box cover, 6 screws ( not all the same length ) then reach inside with a crooked needle nose and remove the snap pin from the govenor link, be sure not to drop the snap pin or the little spacer, then the pump will have to be turned a little so the rack will come through the knotch in the side of the block.
Danny
Parker Equipment Co

 

[Pird]

Thanks Danny. Everything was just as you said and it was pretty straightforward...however some skinny long fingers would have helped. Appreciate it..John /forums/images/graemlins/wink.gif