Replaced dash park brake indicator micro switch - pics

   / Replaced dash park brake indicator micro switch - pics #1  

Mousefield

Elite Member
Joined
Aug 24, 2008
Messages
2,583
Location
Qualicum Beach on Vancouver Island, BC. Canada
Tractor
Sold 2008 CK35 HST
My dash park brake light was staying on all the time. I had tightened the lever, which was a bit loose, but it still stayed on all the time. The steel spring on top was going up and down so figured the switch was stuck, played around with it a bit but stayed stuck. Got a replacement from my dealer and replaced it. First I took off the black fuse box. Then I tried to unscrew the micro switch, no way was it coming off. :mad: So then took the shiny plate that the micro switch was screwed through by removing the two bolts holding the plate on. Once the plate came off I saw why the micro switch was not coming off. :thumbsup: The two long skinny bolts through the micro switch had nuts on the back. :p Once I could grab the nuts then I could unscrew the bolts holding the micro switch to the shinny plate. Got it back together and it is working properly. :D
 

Attachments

  • DashbrakeSwitch 001.jpg
    DashbrakeSwitch 001.jpg
    213.3 KB · Views: 307
  • DashbrakeSwitch 002.jpg
    DashbrakeSwitch 002.jpg
    234.9 KB · Views: 267
  • DashbrakeSwitch 003.jpg
    DashbrakeSwitch 003.jpg
    264.2 KB · Views: 293
   / Replaced dash park brake indicator micro switch - pics #2  
My dash park brake light was staying on all the time. I had tightened the lever, which was a bit loose, but it still stayed on all the time. The steel spring on top was going up and down so figured the switch was stuck, played around with it a bit but stayed stuck. Got a replacement from my dealer and replaced it. First I took off the black fuse box. Then I tried to unscrew the micro switch, no way was it coming off. :mad: So then took the shiny plate that the micro switch was screwed through by removing the two bolts holding the plate on. Once the plate came off I saw why the micro switch was not coming off. :thumbsup: The two long skinny bolts through the micro switch had nuts on the back. :p Once I could grab the nuts then I could unscrew the bolts holding the micro switch to the shinny plate. Got it back together and it is working properly. :D

Sounds like you have the problem fixed for sure.. I sent you an E- Mail as
requested.. Doesn't take much to knock them out of adjustment or have dirt get into them and screw them up. The installation on the CK30 HST is a little different then your tractor but works the same ...
The Fox.
 

Tractor & Equipment Auctions

2016 Chevrolet Silverado 2500 HD 4x4 Crew Cab Pickup Truck (A55973)
2016 Chevrolet...
2025 GPS Trailers (A56858)
2025 GPS Trailers...
2005 PETERBILT 379 TRI AXLE  DUMP TRUCK (A58018)
2005 PETERBILT 379...
2015 Ford E-350 Cutaway Van (A55973)
2015 Ford E-350...
MURRAY PUSH MOWER (A58214)
MURRAY PUSH MOWER...
JLG 1255 Telehandler (A56436)
JLG 1255...
 
Top