RickB or Jbrink64-TD95D engine oil refill quantity

Jbrink64 · Mar 26, 2011

Some of the compacts have 2.

RickB · Mar 26, 2011

Some of the newer NEF "structural" engines have oilpans that come down arounf the front driveshaft like the larger compacts mentioned. These pans all have drains on either side of the driveshaft relief.

Jbrink64 · Mar 26, 2011

RickB said:
Some of the newer NEF "structural" engines have oilpans that come down arounf the front driveshaft like the larger compacts mentioned. These pans all have drains on either side of the driveshaft relief.

Oops, I forgot about those. Sorry, my bad.

Jerry/MT · Mar 29, 2011

Here's the latest from my local New Holland Dealer regarding the oil refill capacity for a TD95D. They admitted the manual specified capacities were in error. They said that this model used several different engines. She asked "So what'sthe correct refill quantity?" and they said the engine was the same as the JX95 (CaseIH) and it used the same dipstick (P/N 99441833). The Case IH numbers say 8.4 quarts to refill the crankcase + 0.74 qts to fill the filter for a total of 9.14 quarts. They apparently never specifically did give her a direct answer to what the TD95D was but it's safe to say that if the correct dipstick is used you will put the correct quantity in the crankcase. The service manager in Dillon (the main office for the local NH dealership) said, since I put three gallons in, drain off a gallon and refill to the dipstick. That will give me an idea of the correct quantity. That's what i was planning on doing. New Holland did say that they are going to revise the manuals.

So until I drain out some oil, I'll go with the 9.14 quarts and use the dipstick to to check.

Thanks to RickB and Jbrink64 and Sweep, who took the time to answer. You guys can mark your manuals with this info until the heavy breathers in Racine send you the manual revisions.(I think CNH is headquartered in Racine aren't they?).

Jbrink64 · Mar 29, 2011

Glad that's taken care of.

Jerry/MT · Mar 30, 2011

Just to close this issue out, I removed about 2.9 quarts of oil from the 12 quarts I put into the crankcase today and that lowered the oil level to the "Max" mark on the P/N 99441833 dipstick in my tractor. This confirms the numbers i got from CNH yesterday.

I would call the engine oil refill capacity of the TD95D with the Iveco 8045.25L engine 9 quarts with an oil filter change.