Rock Bucket Homemade for my 1025R

[k0ua]

All right, you are hired! You can start in the fabrication department on Monday!, and you will start at Master Fabricator/Weldor paygrade:thumbsup:

Good work, and really nice looking too.

 

[Gizmo2]

:thumbsup:

 

[Tejas]

Very nicely done. Get an action photo one of these days.

How did you bend the 1 1/8’? Nice job keeping them all identical.

 

[JKR]

I bent the steel bars with a 16 ton pipe bender. I set the stop for the been after I got the right bend I needed. It was 58 degrees to allow for spring back.
with a 5" radius.

[/URL][/IMG]

 

[Jdkil]

I need to use a rock bucket for some of my land I was working on. I had remove 4 tree stumps and a old rock wall and level out the ground. Now I had a big pile of dirt I need to use but it was full of rock.
I tried to rent a skid steer. No one had it. I then went to buy a rock bucket for my 1025R again one had it for small tractor or modified a bucket that cost $2000 or more.
So I decided to make my own. Off to the metal shop I went. 90' of 1/18" round rod, 2x4 3/16" tube, 3x 3/8" flat stock 2x3/8 flat stock.
I think it came out good and look factory. It also work better that I though. Save my back and worth the time spent making it.
Hear some picture of how I made it and the final Rock Bucket on my 1025R.

Would like to see pictures, it's not allowing Mr to click links

[/URL][/IMG]

[/URL][/IMG]I

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

 

[LS Tractor Owner]

Revitalize an 8 Y/O thread, then don't say anything?

 

[joea99]

10 years old now. The images can no longer be seen. Any way to see them? Thinking of building one myself.