Shifting kubota utv 900
- Thread starter m38a123
- Start date
- Views: 945
ruffdog
Super Star Member
- Joined
- Dec 31, 2011
- Messages
- 12,463
- Location
- southern wisconsin
- Tractor
- Bobcat Toolcat 5610G, Deere X744, Cub Cadet IH 982
Do you pull the knob on the dash that relieves the pressure so it shifts easier? Sometimes I would have to shift by body forward/back to ease the shift too. Some people have installed a "coast valve" that might help.
Cat385B
Silver Member
It helps to be on flat ground, and have coasted to stop rather than using the brakes.
They are touchy about the shifting.
They are touchy about the shifting.
whitetiger
Gold Member
- Joined
- Nov 20, 2004
- Messages
- 373
- Location
- Kansas City, Kansas
- Tractor
- BX2370 Kubota, Ford 1100, MF135
Jack the rear tires up off of the ground, shift to 2 wheel drive, park brake off, start the engine, and put the transmission into gear. Does one of the rear tires spin? If one does, you need to adjust the hydrostat linkage.
There also is a dump valve for the hydro that is connected to the brake linkage. Depending on the production year it can be on the LH or RH side at the rear of the transaxle. It may be stuck or out of adjustment. To shift and RTV, you have to depress the brake pedal fully, which activates the dump valve. A properly adjusted and functioning RTV should shift quite easily.