Sickle Mower Hydraulic

   / Sickle Mower Hydraulic #11  
J J
I am a novice in hydro. Is the float in the valve? I will have to add a valve and any thoughts on Fass'e?
Thanks,
Neil
 
   / Sickle Mower Hydraulic #12  
   / Sickle Mower Hydraulic #13  
Some of the jerkiness is caused by the flex of the cutter bar, but it will jerk less if you raise the height of the cylinder mount on the frame because the vertical component of the initial force is lower. Yes this would alter the range of movment of the cutter bar if you don't also change the lower location.
 
   / Sickle Mower Hydraulic #14  
JJ & ZZ,
Higher on the frame and lower on the bar (closer to the pivot)? I need to study my tractor(IH TC 29) and your comments and get back to you.
Many, many thanks,
Best,
Neil
 
   / Sickle Mower Hydraulic #15  
Last edited:
   / Sickle Mower Hydraulic #16  
JJ,
I found an old post that indicated that the IH 1300 could go as much as 70d below level. Not sure if that is posible but certainly is in agreement with you that I have the drop I need.
Thanks,
Neil
 

Tractor & Equipment Auctions

2011 John Deere 5075 4WD Agricultural Tractor (A52377)
2011 John Deere...
2021 FORD F-150 XL EXT CAB TRUCK (A51406)
2021 FORD F-150 XL...
2017 FREIGHTLINER CORONADO SD122 DAY CAB (A54313)
2017 FREIGHTLINER...
2003 Pierce Spartan Pumper Fire Truck (A51692)
2003 Pierce...
2012 Cadillac CTS Sedan (A53424)
2012 Cadillac CTS...
2013 SHOP BUILT FLARE STACK (A53843)
2013 SHOP BUILT...
 
Top