Side Panels on 2710

   / Side Panels on 2710 #1  

kb2710

New member
Joined
May 21, 2005
Messages
2
HELP! Cannot for the life of me get the engine side panels or the grill on a 2710 to go back on. I've pushed, shoved and tapped them with a rubber mallet.
Are they suppose to slide back on eaisly? The little metal holders in the slots move up/down. Does their postion have something to do with it?
Can someone give me some advice before i get out a sledge hammer and put them back in place?
THANKS!
wayne
 
   / Side Panels on 2710 #2  
OH NO! /forums/images/graemlins/ooo.gif You didn't actually remove those side panels did you?

They are designed to come off but not go back on. You now must return your tractor to the dealer to have them reinstalled /forums/images/graemlins/grin.gif

Seriously, the side panels require considerable force to "snap" back into place. I would not suggest resorting to the sledge hammer as mentioned, however a very serious "rap" with the heel of the hand is required to reattach those on my 7800.

Line them up carefully and give it a good whack with the hand and see if they don't return to their original position

Dan
 
   / Side Panels on 2710 #3  
Just be sure they're lined up right, both the tabs at the bottom as well as the top latches. And when they are, mine always went back pretty easily by just hitting them with the heel of my hand. Forget the hammers and mallets. And of course if you're just pushing against them, that doesn't work very well either.
 
   / Side Panels on 2710
  • Thread Starter
#4  
Ahhhhhh... THANKS!
I was putting them in the wrong holes - idiot me! /forums/images/graemlins/frown.gif
Worked like a charm when I did it right.
Thanks for your help... this is a great site!
wayne
 
   / Side Panels on 2710 #5  
<font color="blue">I was putting them in the wrong holes - idiot me! </font>

You mean there is more than one of us??? /forums/images/graemlins/confused.gif /forums/images/graemlins/blush.gif

Glad to see another new face! Welcome to TBN. Lots of good people and info here... /forums/images/graemlins/smile.gif
 
   / Side Panels on 2710 #6  
There was a reason I said to be sure they're lined up right. It's called experience. /forums/images/graemlins/wink.gif Mine were contrary, too, until I figured that out. /forums/images/graemlins/tongue.gif
 

Tractor & Equipment Auctions

2014 DODGE CHARGER (A51406)
2014 DODGE CHARGER...
Year: 2007 Make: Ford Model: Explorer Vehicle Type: Multipurpose Vehicle (MPV) Mileage: Plate: Body (A55788)
Year: 2007 Make...
2006 Toyota Tundra 4X4 Pickup Truck (A55788)
2006 Toyota Tundra...
2006 Ford Taurus SE Sedan (A54815)
2006 Ford Taurus...
John Deere 6105E Tractor, 105HP, 4WD, Suspension Seat, A/C, 3 Rear Remotes (A55302)
John Deere 6105E...
2013 MACK ELITE LEU613 GARBAGE TRUCK (A51406)
2013 MACK ELITE...
 
Top