wickedinhere
Silver Member
Thanks, I hope i dont have to sleep in my shed lol. I am goin to build mine on skids also just in case i need to move it.
Simple Solar shed
- Thread starter saltman
- Start date
- Views: 4067
andrewj
Platinum Member
hey, I built a little playhouse on 2/6 skids (it was 4 by 6 and made of two by four screwed together with stury outdoor screws. It twisted so much I had to do quite a bit of reworking to make it square again! it did not have sheating on the outside, do youthink that was the key behind the movement?
Buckeye_Jim
Silver Member
Saltman,
Nice job framing with all the gussets and ties and sheathing, I think your building will not be racking or flexing and should be able to survive a big eathquake. How about anchoring? Could a big enough wind knock it over? Out in the plains, one would have some serious anchors on a mobile home for instance.
Jim
Nice job framing with all the gussets and ties and sheathing, I think your building will not be racking or flexing and should be able to survive a big eathquake. How about anchoring? Could a big enough wind knock it over? Out in the plains, one would have some serious anchors on a mobile home for instance.
Jim
Sleeping in a 10x12 loft is just like sleeping in a small bedroom, but you have to go down the ladder to use the bathroom!
Sheeting would have helped I am sure, there are some other variables but 4x6 skids on a building that small are too heavy, everything will move before the skids will since they are the heaviest part of your structure. (I hope that makes sense)
I am not going attempt to drag mine but if I decide to move it I will pour a slab then jack it up and put round metal poles under it and roll it onto the slab. Here is a photo of my dad after our first day of framing and a photo of my skid foundation with pressure treated 2x6 floor joists spaced 16 inch on center. I used 3/4 inch tongue and groove sheeting for the floor. OSB which I will not use again for flooring.
Sheeting would have helped I am sure, there are some other variables but 4x6 skids on a building that small are too heavy, everything will move before the skids will since they are the heaviest part of your structure. (I hope that makes sense)
I am not going attempt to drag mine but if I decide to move it I will pour a slab then jack it up and put round metal poles under it and roll it onto the slab. Here is a photo of my dad after our first day of framing and a photo of my skid foundation with pressure treated 2x6 floor joists spaced 16 inch on center. I used 3/4 inch tongue and groove sheeting for the floor. OSB which I will not use again for flooring.
