Small square baler for JD 5203

[E.B. Haymakin']

The New Holland 273 baler has worked well for me, and my 42 pto NH 3010S. The only problem with the 273 is parts are getting scarce for it. This I am told by a dealer-the unit is not supported by NH any longer. Some parts are still available, because when I ordered them, they showed up.

 

[jimg]

Thanks for all your comments. I am looking at the 3K to 7K range if possible.

I wouldnt expect much for less than $4K unless you get an old mdl. As the previous post mentioned getting parts could prove troublesome for those. On the other end you could find a pretty good newer mdl esp there in the mid-W. Ive seen a number of NH311, 316s for sale in that range + some JD 336, 337 and 338s. Ive heard that MF (offset) balers are quite good but parts can be expensive.