sequoyah101
Silver Member
- Joined
- Nov 13, 2009
- Messages
- 159
- Location
- East Central Oklahoma
- Tractor
- CaseIH 50A, CaseIH JX95, CaseIH JX80, Allis 190XT, Daewoo DD80L Dozer, Schaeff SKL831 Loader, Komatsu PC40-7 Trackhoe, JCB 210S TLB, JD750, JD820, Kubota FR3680, Kioti Mechron
Does anyone know of a reasonably priced alternative to the Stanley nitrogen charge kit for these hammers or know the proper threat for the charge port and where to get it?
I acquired one of these from a combat engineer vehicle. It appears unused and maybe 20 years old. I finally got around to using it and of course the seals are old and quickly failed and it leaks now like a screen door on a submarine.
To replace the seals you have to discharge the nitrogen from the accumulator then recharge it. Stanley wants $600 for the friggin' little charge kit. That is robbery and stupid money. I see all manner of kits on Ebay for the job but not certain the fittings will fit the charge port on the hammer.
Help appreciated of course.
I built a fixture for the quick attach plate and affixed the driver to it, bought a 3" pin driver and it beats pipw in at least 5' so far with little effort. I'd like to get back to post pounding.
I acquired one of these from a combat engineer vehicle. It appears unused and maybe 20 years old. I finally got around to using it and of course the seals are old and quickly failed and it leaks now like a screen door on a submarine.
To replace the seals you have to discharge the nitrogen from the accumulator then recharge it. Stanley wants $600 for the friggin' little charge kit. That is robbery and stupid money. I see all manner of kits on Ebay for the job but not certain the fittings will fit the charge port on the hammer.
Help appreciated of course.
I built a fixture for the quick attach plate and affixed the driver to it, bought a 3" pin driver and it beats pipw in at least 5' so far with little effort. I'd like to get back to post pounding.
