snowbelt geauga
Silver Member
Where is a good source for rebuild parts for an 044 magnum. I need a jug and piston.
Stihl 044 Magnum need parts
- Thread starter snowbelt geauga
- Start date
- Views: 2321
TreePointer
Bronze Member
- Joined
- Sep 30, 2010
- Messages
- 60
BaileysOnline.com is usually the first place I look for chainsaw P&C kits. A quick glance there tells me they have a 50mm Meteor kit and a 52mm NWP big bore kit.
Note that 044 engine changed over the years, so you need to make sure you are getting the correct parts to rebuild your particular 044. The folks in the chainsaw forum at ArboristSite.com should be able to answer all your questions in detail.
Note that 044 engine changed over the years, so you need to make sure you are getting the correct parts to rebuild your particular 044. The folks in the chainsaw forum at ArboristSite.com should be able to answer all your questions in detail.
No way no how no more baileys BS.
Here are lot better picks.
Small Engine Parts: Chainsaw Parts & Small Engine Repair Parts
Chainsaw Parts
HLproparts gives 10% of the order if you are a member of Chainsaw Repair site and use code from there too. http://chainsawrepair.createaforum.com/index.php
Here are lot better picks.
Small Engine Parts: Chainsaw Parts & Small Engine Repair Parts
Chainsaw Parts
HLproparts gives 10% of the order if you are a member of Chainsaw Repair site and use code from there too. http://chainsawrepair.createaforum.com/index.php
I would find a good used OEM cylinder and get a meteor piston for it. I have a Hyway piston and cylinder on a 024, it came from Weedeater man. You need to figure out if you have a 10mm or 12mm wrist pin before you order your piston cylinder kit.
toomuchjunk
New member
Best way to know for sure which size wrist pin you have is to pull the piston pin and measure it. There was a serial number break but on this old of a saw, the numbers may not tell the whole story.
