still blowing white smoke

jpig · Jul 13, 2005

I have a new 5205 with 28 hours on it. It smokes at start up for a few minutes. After it gets up to temp. all is well. It seems to run fine. If I shut it off and let it set for about five minutes and start it again it starts just fine, but when I accelerate it starts bellowing white smoke acts like its running on 2 cylinders. Does this for about 30 seconds and then clears up and runs fine. All of this is with no load. Help!

BigAl · Jul 13, 2005

White smoke is usually unburned fuel . Call the dealer and make them repair it .Could be timing pump or ? At 28 hours total time there is no excuse for this happening on a new unit . And make them give you a new hat too for your problems ! /forums/images/graemlins/wink.gif
Allen

RRacing · Jul 14, 2005

My local dealer had a simular problem with a 5000 series tractor, They changed out the turbo and a bunch of other parts. Turned out to be injectors.

goodolboy · Jul 14, 2005

You have had some good suggestions aready, A couple of other things it may be is, inoperative preheater, coolant leak into the cyl. , and fuel quality. Because of your indication it runs like it is on 2 cyl and then clears up after a short time my hunch is an injector.