Sunshades

[5030]

Interesting. Mine don't shake or vibrate at all. Far as hitting stuff, my other tractor is a cab M9 so I'm always cognizant of height. If you put the 2 side by side, it's no higher than my cab tractor

View attachment 616549

as you can see, I don't worry about a car port or a garage door not that my tractors would fit in a garage anyway.

 

[5030]

I do have to say that my 'hardware bag' was missing 2 of the little rubber bumpers so I called the manufacturer (Femco) told them I was shorted 2 and they sent me 2, no charge right away. Good customer service. Bought it (Tuff Top) from All States Ag. Shipped quick (1 week) and free shipping.

Yesterday I was out brush hogging and a big bird flew overhead and dropped a load of poop and it landed on the top. Without the top on, it would have landed on my bald head. Not good.:laughing:

 

[Imold]

I知 thinking of putting a eyelet/hole in the front end of each support arm and run a line/ small ratchet strap down to a attachment area on each side of the FEL and see if that will make a big enough of a difference so I don稚 have to remove it to trailer it. Something like this ruff drawing just for trailering purposes then remove the line/strap when I get to where I am going..


Jim.

 

[5030]

Drop your ROPS and fold the canopy against it.

 

[Imold]

Drop your ROPS and fold the canopy against it.

The ROPS on the 1705 do not fold over being they are not tall like TLB. The sunshade just folds over and is like a sail against the ROPS.

Jim.

 

[milkman]

This one's homemade from some aluminum diamond plate I had laying around, a little short so I added an extension to the front.

 

[Imold]

Nice looking sunshade you made also like the chainsaw mount.

Jim.