TC30 Loader Waving In The Wind
- Thread starter jjcc246
- Start date
- Views: 2317
I haven't got it fixed yet. Some parts are in but not the orfice. I found out about the problem by trying to back drag with the bucket and had no pressure to hold the bucket in position. When I called the dealer about the problem, they called New Holland, they knew about the problem and suggested the fix. When the orfice comes in I'm going to install it myself and I'll post the results.
the fix is in. part numbers are 1-fitting, SML 60591, 1-fitting SML 33330 and 1-orfice 86585465. Very easy to replace. It goes at the control lever box. Dissconnect the bucket cylinder rod hose and put the new fittings between the hose and the control box. This is a NH fix and they are well aware of the problem. The parts were covered under warranty. i'm going to try and attach an diagram.
i called the dealer and explained the problem. they contacted NH and now there is a repair notice on it. the dealer was explaing that Nh has a new system that they pop a problem into a computer system and it checks worldwide for the same problem and finds the repair. if the problem hasn't been noted yet the techs look into it and come up with a solution. when they get enough complaints on the same problem they put a tech bulletin out with the fix, as they did with my problem. at any rate, i'm rambling here, they know about the problem and have the fix. i don't know if the tc18 uses the same orfice though.
